AT-EE12 · Protection
Underground Cable Fault Locator
Shows the distance to a cable fault in kilometres on a display.
- Suits
- Sem 5–8
- Branches
- EEE
- Type
- Hardware model
How it works
Each kilometre of cable is represented by a set of resistors in series, and switches along the line create a fault at a chosen point. A fault changes the resistance seen from the starting end. The Arduino measures the voltage drop across the line, works out the resistance and converts it into distance, shown in kilometres on the LCD for each of the three phases.
What it does
- Three-phase model
- Distance readout
- Fault type indication
Main parts
Arduino, resistor network, relays, LCD
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-BE06Over-Voltage and Under-Voltage ProtectionCuts off the load when the supply goes above or below safe limits and reconnects when it is normal.
- AT-EL05Motor Overload Protection SystemMeasures motor current and trips the supply when it stays above the safe limit.
- AT-EL06Phase Failure and Phase Reversal ProtectionStops a three-phase motor if a phase is missing or the sequence is wrong.
- AT-EL14Transformer Overload and Temperature ProtectionDisconnects the load when a small transformer overheats or is overloaded.