AT-EL03 · Electrical machines
Closed-Loop Motor Speed Control with RPM Display
The controller holds the set speed even when the load changes and shows live RPM.
- Suits
- Sem 5–6
- Branches
- EEE
- Type
- Hardware model
How it works
A sensor on the shaft produces pulses as the motor turns, and the Arduino counts them to get the actual RPM. This is compared with the speed set on the knob. A PID routine uses the difference to raise or lower the PWM to the motor. When load is added and the motor slows, the controller gives more power and brings the speed back to the set value.
What it does
- RPM feedback
- Set speed by knob
- PID control
Main parts
Arduino, encoder or IR sensor, motor driver
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-EL01DC Motor Speed Control Using PWMTurn a knob to change the speed of a DC motor smoothly from stop to full speed.
- AT-EL02DC Motor Direction ControlRun a DC motor forward, reverse or stop with push buttons using relay switching.
- AT-EL04Star-Delta Starter ModelShows how a motor starts in star and shifts to delta after a set time, using relays and a timer.
- AT-EL07Stepper Motor Position ControlEnter an angle on the keypad and the stepper motor turns exactly to that position.