AT-FY05 · Arduino
Automatic Hand Sanitizer Dispenser
Hold a hand under the nozzle and a small pump gives a measured amount of sanitizer without any contact.
- Suits
- Sem 1–4
- Branches
- ECE, EEE, CSE, ISE, AIML, Mechatronics
- Type
- Hardware model
How it works
An IR sensor under the nozzle sends out infrared light and watches for the reflection. A hand placed below reflects the light back, and the Arduino takes that as a request. It switches a relay that runs a small pump for a fixed time, so the same amount comes out every time, and then waits for the hand to be removed before it will dispense again. A level check warns when the bottle needs a refill.
What it does
- Contactless sensing
- Fixed dose per use
- Refill indicator
Main parts
Arduino, IR sensor, mini pump, relay
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-FY04Smart Dustbin with Automatic LidThe lid opens when a hand comes near and closes by itself, so nobody touches a dirty bin.
- AT-FY06Automatic Plant Watering SystemA soil moisture sensor switches the pump on when the soil is dry and off when it is wet enough.
- AT-FY08Smart Parking AssistantGreen, yellow and red lights tell the driver how close the car is to the wall, with a buzzer at the stop point.
- AT-FY21Traffic Light ControllerRed, yellow and green lights run in a timed sequence for a junction, with a button for pedestrians to cross.