AT-FY21 · Arduino
Traffic Light Controller
Red, yellow and green lights run in a timed sequence for a junction, with a button for pedestrians to cross.
- Suits
- Sem 1–4
- Branches
- ECE, EEE, CSE, ISE, AIML, Mechatronics
- Type
- Hardware model
How it works
The Arduino runs the lights of the junction in a fixed order: green, yellow, red, each for a set time, and then moves to the next road. A push button is provided for pedestrians. When it is pressed the Arduino remembers the request, finishes the current green safely, holds all vehicles on red and gives the walk signal. All the timings can be changed in the program.
What it does
- Timed signal cycle
- Pedestrian button
- Adjustable timings
Main parts
Arduino, LEDs, push button
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-FY04Smart Dustbin with Automatic LidThe lid opens when a hand comes near and closes by itself, so nobody touches a dirty bin.
- AT-FY05Automatic Hand Sanitizer DispenserHold a hand under the nozzle and a small pump gives a measured amount of sanitizer without any contact.
- AT-FY06Automatic Plant Watering SystemA soil moisture sensor switches the pump on when the soil is dry and off when it is wet enough.
- AT-FY08Smart Parking AssistantGreen, yellow and red lights tell the driver how close the car is to the wall, with a buzzer at the stop point.