AT-BE14 · Arduino
Temperature and Humidity Monitor
Shows room temperature and humidity on a display and warns when either crosses a limit.
- Suits
- Sem 3–4
- Branches
- ECE, EEE, Mechatronics
- Type
- Hardware model
How it works
The DHT11 sensor measures the temperature and the moisture in the air and sends both values to the Arduino as digital data. The Arduino shows them on the LCD and refreshes every couple of seconds. Each reading is compared with the high and low limits you set, and the buzzer sounds if either one goes out of range.
What it does
- DHT sensor
- High and low alerts
- LCD display
Main parts
Arduino, DHT11, LCD, buzzer
What you get
- Working model, tested before dispatch
- Program code and wiring details
- Rough report and explanation of the working
- Live demo on video call before the final payment
Good to know
- This is a table-top demonstration model on low voltage, not a full-size product.
- Features are as listed here. Anything extra is quoted separately.
- Shipping is charged at the actual courier rate.
- Full reports and PPTs are not included.
Similar projects
- AT-FY04Smart Dustbin with Automatic LidThe lid opens when a hand comes near and closes by itself, so nobody touches a dirty bin.
- AT-FY05Automatic Hand Sanitizer DispenserHold a hand under the nozzle and a small pump gives a measured amount of sanitizer without any contact.
- AT-FY06Automatic Plant Watering SystemA soil moisture sensor switches the pump on when the soil is dry and off when it is wet enough.
- AT-FY08Smart Parking AssistantGreen, yellow and red lights tell the driver how close the car is to the wall, with a buzzer at the stop point.